Posts by DaveHauser
Archdale Metallic
Problem: Client wanted a seamless metallic floor for his basement bathroom. Solution: Clean and grind the floor per SSPC SP-13, apply ⅛” urethane cement, apply one coat of 100% solids epoxy primer, apply one coat of self leveling 100% solids clear epoxy with metallic pigments added and create the desired effect.
Read MoreKernersville Commercial Floor
Problem: Client was installing a clean room in this facility and needed a clean, seamless floor. Solution: Clean and grind floor per SSPC SP-13, fill cracks and control joint with an epoxy mortar and grind smooth, apply one coat of 100% solids epoxy primer, apply one coat of self leveling 100% solids epoxy, and topcoat with a moisture cured urethane.
Read MoreWater Storage Tank
Problem: Tank had not been coated in decades and was covered in mildew that couldn’t be easily washed off. The tank also had several concrete spalls. Solution: Pressure washed the tank per SSPC SP-1, prepared the concrete spalls per SSPC SP-13, repaired the concrete spalls with a high strength repair mortar, applied a low viscosity epoxy primer for maximum penetration, then applied 2 coats of high performance, mildew resistant, acrylic coating.
Read MoreCarbon Silo
Problem: Old, unsightly coating that was difficult to keep clean. Solution: Pressure washed per SSPC SP-1, Power Tool per SSPC SP-3, primed with one coat of polyamide epoxy, applied two coats of high gloss aliphatic polyurethane that will be easy to keep clean, applied decals for identification.
Read MoreGreensboro Acid Stain
Problem: Client wanted a rustic, mottled look on the floor in her workout room. Solution: Clean and grind the floor per SSPC SP-13, stain the concrete floor utilizing an acid stain, let stain sit overnight then neutralize and clean the acid residue, apply 2 coats of clear moisture cured urethane.
Read More